Ip Route Multi-Path - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip route multi-path

ip route multi-path
no ip route multi-path
Syntax
Description
Default
Command Mode
Usage Guideline
Examples
Switch(config)# ip route multi-path
Switch(config)# no ip route multi-path
CLI Reference Guide
Use ip route multi-path to enable multiple paths for same route. Use the no form
of the command to disable multiple paths.
None
Enabled
Global configuration
If there are multiple routes with the same network-prefix co-existing, specify the
route operation mode (multi-path or not) to select the routes that will be active.
For the no command, it disables the multiple path function. Only one of the
multiple paths will be active.
Note: The active path may change from one path to the other under multiple
paths mode, as long as the available route with a greater priority becomes
reachable.
This example shows how to enable multiple paths function.
This example shows how to disable multiple paths function.
Verify the settings by entering the show ip route summary command.
ip route multi-path
310