Table of Contents
Advertisement
Message
Meaning
ANT DC OUT terminal
There has been a current
is over current.
overload at the ANTENNA a/b IN
connector.
Transmitter's battery
The transmitter's battery is weak.
level is low.
Receiver cannot decrypt
Encrypted transmission settings
the encrypted signal.
on the receiver and the
transmitter do not match.
RF level is excessive.
The signal reception level is
excessively high.
RF level is low.
The signal reception level has
dropped.
Quality level is low.
The quality of received audio data
is deteriorated.
Audio signal is reached
The audio input level on the
clipping level.
transmitter is excessive.
Communication time-
The number of retries has
out occurred.
exceeded the limit and a timeout
error has occurred.
CPU EEPROM error
A CPU EEPROM error has
occurred.
occurred.
RF EEPROM error
An RF circuit EEPROM error has
occurred.
occurred.
Receiver's codec mode
The codec modes of the
is mismatched with
transmitter and receiver do not
Transmitter's codec
match.
mode.
Other event messages
The messages that appear are as follows.
Message
Meaning
Communication was
Recovered from a communication
enabled.
timeout.
The process of loading
Loading of settings is complete.
settings was finished.
The process of loading
Loading of settings has failed.
settings was failed.
The process of
Transition into online mode is
changing in Online
complete.
mode was finished.
The process of
Transition into online mode has
changing in Online
failed.
mode was failed.
The process of
Transition into offline mode is
changing in Offline
complete.
mode was finished.
The process of
Search processing is complete.
searching devices was
finished.
The number of new
XX number of DWR units have
DWR: XX
been newly detected.
The number of new
XX number of RMU units have
RMU: XX
been newly detected.
[Property List] Tab
This tab displays a list of settings for the receiver channels
displayed in the status viewer. When you change the page
displayed in the status viewer, this change is also reflected
in the settings displayed in the [Property List] tab.
You can change setting values in the [Property List] tab by
selecting the cells. By selecting multiple cells, you can
change the setting values for multiple receiver channels as
a group.
1
2
a [Name] field
Displays the name of the page currently displayed in the
status viewer.
b Settings list
Displays a list of settings for the device displayed in the
status viewer.
You can change setting values by selecting the cells in the
list. When you click a cell and select a value from the list
of options that appears, the setting value is applied to the
respective receivers and transmitters.
Cells displayed in yellow indicate that the wireless remote
control signal strength is low or that setting values failed to
be applied for the respective receiver channels. In such
cases, try configuring the settings again. When the settings
are successfully configured, the cell will change from
yellow to the standard color. You can also clear the yellow
indications by clicking the [Clear Indication] button.
You can also select multiple cells using any of the
following methods. When multiple cells are selected, the
setting values for the selected receiver channels can be
changed simultaneously.
• Click and drag over the cells.
• Click the cells one at a time while holding down the Ctrl
key.
• Click two cells that are not neighboring while holding
down the Shift key.
c Displayed setting items checkboxes
Select whether to display or hide setting items in the
[Property] window by category.
For details on the [Property] window, see "[Property]
Window" on page 44.
33
3
4
5
Advertisement
Table of Contents
