Table of Contents
Advertisement
Device Detection and Monitoring
1
Select [Start] > [All Programs] > [Sony] > [Digital
Wireless Microphone System] > [Wireless Studio] to
start up the software.
2
Place a check mark next to [Online monitoring and
control] in the [Device] menu.
The system enters online mode, and the receivers and
RMU-01 units are automatically detected and added to
the [Device List] window.
Receivers that are added to the device list are
automatically registered to the [All tuners] page of the
status viewer where they can then be monitored.
For more information on window contents, see "Status
Viewer and Meter Icons" on page 29.
Note
The Windows firewall or your security software's
firewall may prevent devices from being detected
automatically. If the devices are not detected
automatically, disable the firewall settings.
To monitor a particular set of receiver channels
Display a page in the status viewer other than the [All
tuners] page, and register receiver channels manually to
monitor only the receiver channels that you select.
To display a receiver channel in the status viewer, drag the
receiver channel selected in the device list and drop it in
the status viewer, or right-click the receiver channel and
select [Add to Status Viewer] in the context menu that
appears.
The following methods are available for selecting receiver
channels.
• When you click a single receiver channel, that receiver
channel is selected.
• When you click a receiver, the two receiver channels that
are built into that receiver are selected.
• When you click and drag on the background area, all of
the receiver channels within the dragged area are
selected.
• When you click receiver channels while holding down
Click [+] to the
the Shift key or Ctrl key, all of the clicked receiver
left of a receiver
channels are selected.
icon to display
the receiver
channels.
Note
When [Main display] is set to [Simple] and the simple
status viewer is displayed for the main window, receiver
channels cannot be registered to pages other than the [All
tuners] page.
To set devices to be excluded from automatic detection
Use the [Omit IP address list] window (see page 52).
15
Advertisement
Table of Contents
