Table of Contents
Advertisement
If Problems Occur during Monitoring
See the following table to remedy the problem.
Problem
Cause
The receiver is
The host name or IP
not recognized.
address is already
assigned to another
device.
It takes long
If the network has a PC
until the
that is connected to a
receiver is
broadband router or the
recognized.
Internet, it may take
several minutes to
recognize the receiver.
In the dialog
If your PC is equipped
box indicating
with or connected to a
the receiver
modem or ISDN router,
detection
the Wireless Studio
results, an
software may not
abnormal value
function properly when
appears in the
you start it up when
IP address
either of the conditions
field.
described below exist.
This is because the PC
will attempt to detect
device through the
modem or router.
• The receiver is turned
off.
• The LAN cable is
disconnected.
The receiver is
The Windows firewall or
not detected
your security software's
automatically.
firewall may prevent
devices from being
detected automatically.
The "Wireless
Wireless Studio Ver. 3.0
Studio
or later supports Ver.
detected
1.20 or later of the
version
DWR-R01D firmware.
unmatch with
DWR-R01D.
Please update
the firmware of
DWR-R01D to
ver.1.20 or
later" message
appears, and
monitoring is
disabled.
Selecting Channel Plans
To ensure stable operations, select a channel plan that is
suitable for your signal environment.
Remedy
In Wireless Studio, you can ensure more stable operations
by performing the procedure found in [Channel Plan
Check the host
name or IP
Adviser] to select channel plans.
address settings.
The following modes are available in [Channel Plan
Construct a
Adviser].
separate
Basic mode: This mode allows you to select a channel plan
network apart
that avoids signal interferences detected by the receiver's
from the one
channel scan function.
containing the
PC with the
Advanced mode: In addition to performing channel scan
broadband
as in basic mode, this mode allows you to select a channel
router or the
plan while taking into account frequencies that are being
Internet
used by known TV broadcasts or other wireless devices.
connection.
Turn on the
For details, see "[Channel Plan Adviser] Window" on
receiver and
page 47.
make sure the
LAN cable is
connected.
This section describes how to select channel plans using
the simpler basic mode.
For details on selecting channel plans using advanced
mode, see "Selecting the channel plan" on page 49.
1
Disable the
firewall settings
2
on the computer.
Update the
firmware of the
receivers. For
details, contact
your Sony
dealer.
16
Place a check mark next to [Online monitoring and
control] in the [Device] menu.
The system enters online mode, and the receivers are
automatically detected and added to the [Device List]
window.
Select [Device] menu > [Channel Plan Adviser].
The following screen appears, and [Channel Plan
Adviser] starts.
Advertisement
Table of Contents
