Table of Contents
Advertisement
Connecting Test Fixtures
If you speci ed test xtures, your HP 4062C or HP 4062UX includes the HP 16370A
Test Fixture Adapter and the following test xtures to satisfy virtually any measurement
application.
HP 16371A 24-pin DIP Low Leakage Fixture
HP 16372A 48-pin DIP Low Leakage Fixture
HP 16373A 64-pin DIP Low Leakage Fixture
HP 16374A Universal Low leakage Fixture
HP 16375A General Purpose DIP Fixture
HP 16376A/B Universal Fixture
Use the following procedure to connect test xtures to the SWM.
1. Turn the test xture adapter and the test xture upside down.
2. Position the test xture in the test xture adapter and push the black push-to-lock
fasteners on the test xture to lock the test xture onto the test xture adapter.
3. Turn the adapter over again (topside up).
4. Position the adapter on the SWM.
5. Push the right and left side levers of the test xture adapter down to secure the adapter on
the SWM.
Do not touch the measurement pins of the SWM or the test xture.
Caution
Oil, perspiration, and dirt prevent good electrical contact and degrade
measurement accuracy.
For complete information on a speci c test xture, refer to
xture.
for that test
Operating Note
Switching Matrix Installation 3-11
Advertisement
Table of Contents
