Nylon washer
Cover
1. Remove the six (6) screws securing the
cover, then draw it upward and
disconnect.
Connectors to be removed in Step 2:
JOEP, JOFP, JOES, JOFS
Brake OFF switch cable, four (4) air
tubes
Cover
3.
Remove the cover at the lower side
of the arm 2.
Fig. 5.4 (1) Procedures for relocating wiring panel
TRANSPORTATION AND INSTALLATION MANUAL
Cover
2. Remove the four (4) screws securing
the wiring panel, then dismount the
wiring panel. As all cables are
connector-connected, disconnect all
cables connected there. The gasket
for the panel should remain attached
to the steel plate securing the cover.
4. Mount the wiring panel which was
dismounted in Step 2.
– 63 –
Wiring panel
STE80753