Release 7.0.0 3DB 19286 ACAA Issue 01
Upgrade a Ring to R5.1.0 software
54.3 Procedure
1. Download the R5.1.0 software to all Ring Nodes.
2. Verify that no fault condition exists on the Ring.
3. Activate a Tx mute on Ring Node B toward Node C, see
Figure 389
Activate Tx mute to Node C
4. Activate the R5.1.0 software on Node B, see
580
cause the Ring to enter protection state.
R5.1.0 on Node B does not impact the Ring status, which prevents any
dependency on the time sequence of the upgrade of the East and West radio
interfaces. TDM and Ethernet traffic entering Node B is lost when the interface
toward Node A goes down due to radio interface upgrade, and is restored when
it is back up.
WebEML User Manual
Figure
389. This will
Figure
390. The activation of