Mitsubishi Electric MELSEC Q Series Reference Manual page 531

(2) Icon
The status of each station and status between stations are displayed.
(a) Station No.
1 to 120: Displays the station No. of the CC-Link IE Controller Network module.
Undef.: Displayed for the station for which parameters have not been set
*1 For display of the station for which parameters have not been set, there are restrictions on the CC-Link IE Controller
Network module versions.
Check the serial No. and software version for applicability. (
(b) Connected Station
This is displayed for the station connected to the programming tool (own station).
(c) Icon
When double-clicking the station icon, the "System Monitor" window is displayed. (
10.3.4)
The icons that may be displayed are listed below.
Icon
Normally operating station
Faulty station (a fault has occurred on a module, board, display, or cable while cyclic transmission is
performed.)
Faulty station (Cyclic transmission is stopped.)
Station in a different shared group (no cyclic data are received.)
Disconnected station (black)
Reserved station (gray)
Selected station (station icon edged with green)
• This can be selected by clicking a station icon or moving a focus and holding down a space bar.
• The detailed information is displayed at "Selected Station's Network Equipment Status".
• In addition, disconnected station and reserved station cannot be selected.
Focusing (station icon edged with dotted line)
• Holding down a space bar makes a station to be selected station.
• In addition, disconnected station and reserved station cannot be selected.
Communication error
• If the station adjacent to the one where a communication error occurs is selected, detailed information is
displayed at "Selected Station's Network Equipment Status".
CHAPTER 10 TROUBLESHOOTING
*1
or station No. is not assigned.
Page 606, Appendix 3)
Description
10
Page 536, Section
529