Mitsubishi Electric MELSEC Q Series Reference Manual page 181

(2) Parameter list for normal stations
Item
Network Type
Starting I/O No.
Network No.
Total Stations
Network
setting
Group No.
Station No.
Mode
Station No. setting
method
Refresh Parameters
Interrupt Settings
Redundant Settings
Interlink Transmission Parameters
Routing Parameters
*1 A default value has been set. Change it if necessary.
1) Safety CPU
2) Basic model QCPU
3) High Performance model QCPU
Description
Select the station type of the CC-Link IE Controller
Network module.
Set the start I/O number of the CC-Link IE Controller
Network module in 16-point units.
Set a network No. of the network to which the CC-
Link IE Controller Network module is connected.
Set the total number of stations in one network.
Set a group No. for performing transient
transmission by group specification.
Set a station No. of the CC-Link IE Controller
Network module.
Select an operation mode of the CC-Link IE
Controller Network module.
For Universal model QCPUs, select how to set
station Nos. of normal stations.
Set the range of the transfer between the link
devices of the CC-Link IE Controller Network
module and the CPU module devices.
Set the conditions for sending an interrupt request to
the CPU module.
For a Redundant CPU, set the operation mode of
the CC-Link IE Controller Network module on
system B.
Set the link device transfer range between network
modules.
Set a relay station in the own network to transmit
data to another network.
CHAPTER 6 PARAMETER SETTING
4) Process CPU
5) Redundant CPU
6) Universal model QCPU
CPU module
1) 2) 3) 4)
× × × ×
*1 *1 *1 *1
× × × ×
×
× × × ×
× ×
: Setting required, : Set it if required, ×: Setting not allowed
Reference
section
5) 6)
× ×
Page 180,
*1 *1
Section 6.2
×
Page 204,
Section 6.5
Page 225,
Section 6.6
Page 231,
×
Section 6.7
Page 232,
Section 6.8
Page 238,
Section 6.9
179
6