Siemens SINUMERIK 840D Series Diagnostics Manual page 577

11.02
No. 12
Explanation
Not allowed if
Remedy
No. 13
Explanation
Not allowed if
Remedy
No. 14
Explanation
Not allowed if
Remedy
No. 15
Explanation
Not allowed if
Remedy
No. 16
Explanation
Not allowed if
Remedy
No. 17
Explanation
Not allowed if
Remedy
No. 18
Explanation
Not allowed if
Remedy
No. 19
Explanation
Not allowed if
Remedy
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Perform user interrupt at block end (VDI signal: ASUP interface, digital-analog interface)
See 10
-
Perform rapid retraction (VDI signal: digital-analog interface and asynchronous subroutine
interface, for further actions see 10, 11, 12, 85, 86)).
-
-
Move tool - only with tool management (PI command)
-
-
Perform delete distance-to-go or axis synchronization (VDI signal: delete distance-to-go
or follow-up mode) (follow-up mode: e.g. when switching on an axis movement)
1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
> Abort program
> Abort program
Abort the subroutine repetition (VDI signal: delete subroutine number of passes)
1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized
(occurs when deceleration takes place over several blocks).
> Abort program
> Abort program
Abort subroutine execution. (VDI signal: abort program level)
1. Nesting depth too great
2. The active block, after which deceleration takes place, cannot be reorganized (occurs
when deceleration takes place over several blocks).
> Abort program
> Abort program
Activate single block (VDI signal: activate single block)
-
-
Deactivation of single block. (VDI signal: activate single block)
-
-
1 Alarms
1-577