Siemens SINUMERIK 840D Series Diagnostics Manual page 229

11.02
Definitions:
Reactions:
Remedy:
Program Continuation:
16760
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16761
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16762
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
No Stop is needed for the programmed function. A Stop is necessary after SPOSA or
after M5 if the next block is to be applied only after the spindle has come to a stop.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Do not write instruction.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis %3 S value missing
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
No spindle speed has been given for rigid tapping (G331 or G332).
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Program the spindle speed under address S in [rpm] (in spite of axis mode); the direction
of rotation is given by the sign of the spindle lead.
Positive thread lead: Rotational direction as M03.
Negative thread lead: Rotational direction as M04.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 axis/spindle %3 not programmable in the channel
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Mistake in programming: The axis/spindle cannot be programmed in the channel at this
time. This alarm can occur when the axis/spindle is being used by another channel or by
the PLC.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program, use "GET()".
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 spindle %3 thread function is active
%1 = Channel number
%2 = Block number, label
%3 = Spindle number
Mistake in programming: The spindle function cannot be executed at the present time.
This alarm occurs when the spindle (master spindle) is linked with the axes by an interpo-
lation function.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
Modify part program. Deselect thread cutting or tapping.
Clear alarm with NC START or RESET key and continue the program.
1 Alarms
1-229