Acceptance Test Procedure; Acceptance Report; Plant Description - Documentation Part 1 - Siemens SINAMICS S120 Function Manual

8.2

Acceptance test procedure

Note
The acceptance test is used to check that the safety functions have been correctly
parameterized. The measured values (e.g. distance, time) and system behavior identified
(e.g. initiation of a specific stop) within the acceptance test are used to validate configured
safety functions. The objective of an acceptance test is to identify potential configuration
errors or to record the valid configuration.
8.3

Acceptance report

8.3.1

Plant description - Documentation part 1

Table 8-2 Machine description and overview diagram
Designation
Type
Serial number
Manufacturer
End customer
Electrical drives
Other drives
Overview diagram of machine
Table 8-3 Values of relevant parameters
Versions of the firmware and of Safety Integrated
Parameter
Control Unit
Safety Integrated
Function Manual, (FHS) , 07/2007 Edition, 6SL3097-2AR00-0BP0
FW version
r0018 =
Acceptance test and acceptance report
8.2 Acceptance test procedure
-
-
101