Siemens SINUMERIK 840Di sl Programming Manual page 500

Tables
12.4 List of predefined subprograms
CPROT
INT: Number of
protection zone
NPROT INT: Number of
protection zone
EXECUTE VAR INT: Error
status
13. Preprocessing/single block
STOPRE
500
INT: Option REAL: Offset of
protection zone
0: Protection
in 1st geometry
zone OFF
axis
1: Preactivate
protection zone
2: Protection
zone ON
3: Preactivate
protection zone
with conditional
stop, only with
protection zones
active.
INT: Option REAL: Offset of
protection zone
0: Protection
in 1st geometry
zone OFF
axis
1: Preactivate
protection zone
2: Protection
zone ON
3: Preactivate
protection zone
with conditional
stop, only with
protection zones
active
EXECUTE: Activate program execution. This switches back to normal program
execution from reference point editing mode or after setting up a protection zone.
Stop processing: Preprocessing stop until all prepared blocks are executed in main
run
REAL: Offset of REAL: Offset of
protection zone protection zone
in 2nd geometry in 3rd geometry
axis axis
REAL: Offset of REAL: Offset of
protection zone protection zone
in 2nd geometry in 3rd geometry
axis axis
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Channel-
specific
protection
zone
ON/OFF
Machine-
specific
protection
zone
ON/OFF
Fundamentals