Table of Contents
Advertisement
11.4 Group adjustment
11.4.1 Configuration of group adjustment
11.4.2 Setting up the group adjustment trigger channel
Bosch Motorsport
Group adjustment is the simultaneous online calibration of several channels. This is useful
e.g. to set all wheel forces and damper positions to '0' when the vehicle is positioned on a
flat patch.
Group adjustment consists of two components:
– An input channel which triggers the adjustment event
– A group of input channels linked to the group adjustment event
1.
Click 'Measurement Sources' in the Toolbox.
2.
Drag the 'Group Adjustment Channel' element from the Toolbox and drop it on the C
60
A 'Group Adjustment Channel Wizard' opens.
NOTICE
If a low-active signal is selected as an input channel, do not forget to
enable the pull-up resistor for the pin. Otherwise the group adjust-
ment will be triggered periodically.
See chapter 'Configuring a generic linear sensor [} 39]' for further information concerning
the pull-up-resistor.
3.
Click 'Next' when done.
The second part of the 'Computed Sensitivity / Offset Wizard' opens.
Data Logger C 60
Online Measurement | 11
Select the pin to which
the sensor shall be
connected
Check the box to activate
the internal DDU 8 pullup-
resistor and set the resistor
value
75 / 108
Advertisement
Table of Contents
