Selection Of Command Source; Digital Input (Din) - Siemens MICROMASTER 440 Operating Instructions Manual

3 Functions
3.5.7.2

Selection of command source

Selection of
P0700 =...
command source
Selects digital command source.
0 Factory fault setting
1 BOP (keypad)
2 Terminal
4 USS on BOP link
5 USS on COM link
6 CB on COM link
3.5.7.3

Digital input (DIN)

Function digital input 1
P0701 = ...
Terminal 5
1 ON / OFF1
Function digital input 2
P0702 = ...
Terminal 6
12 Reverse
Function digital input 3
P0703 = ...
Terminal 7
9 Fault acknowledge
Function digital input 4
P0704 = ...
Terminal 8
15 Fixed setpoint (Direct selection)
P0705 = ... Function digital input 5
Terminal 16
15 Fixed setpoint (Direct selection)
Function digital input 6
P0706 = ...
Terminal 17
15 Fixed setpoint (Direct selection)
Function digital input 7
P0707 = 0
Via analog input, Terminal 3
0 Digital input disabled
Function digital input 8
P0708 = 0
Via analog input, Terminal 10
0 Digital input disabled
P0724 = ... Debounce time for digital inputs
Defines debounce time (filtering time) used for digital inputs.
0 No debounce time
1 2.5 ms debounce time
2 8.2 ms debounce time
3 12.3 ms debounce time
P0725 = ... PNP / NPN digital inputs
Change-over (toggles) between high active (PNP) and low active (NPN). This applies to all
digital inputs simultaneously.
0 NPN mode ==> low active
1 PNP mode ==> high active
98
2
BOP
Terminals
P0700 = 2
USS
BOP link
USS
COM link
CB
COM link
1
Possible Settings:
0 Digital input disabled
1 ON / OFF1
2 ON + Reverse / OFF1
12
3 OFF2 – coast to standstill
4 OFF3 – quick ramp-down
9 Fault acknowledge
10 JOG right
9
11 JOG left
12 Reverse
13 MOP up (increase frequency)
14 MOP down (decrease frequency)
15
15 Fixed setpoint (Direct selection)
16 Fixed setpoint (Direct selection + ON)
17 Fixed setpoint (Binary coded selection + ON)
21 Local/remote
15
25 DC brake enable
29 External trip
33 Disable additional freq setpoint
99 Enable BICO parameterization
15
0
ON > 3,9 V, OFF < 1,7 V
DIN7
1
2
0
3
4
MICROMASTER 440
Issue 10/06
Sequence control
Setpoint Motor
channel control
DIN8
1
2
10
11
3
1
Operating Instructions
6SE6400-5AW00-0BP0