Vlan Settings Parameters - Toshiba IP4100 Installation Manual

BASE STATION CONFIGURATION
Table 3-9

VLAN Settings Parameters

Parameter
VLAN ID
VLAN User Priority
Table 3-10 DHCP Options Parameters
Parameter
DHCP Option Plug and Play
Table 3-11 NAT Settings Parameters
Parameter
Enable RPORT
Keep alive time
IP4100 Install Sept., 2013
Enter the unique identifier (0-4094) for the 802.1Q Virtual LAN that this
base station belongs to. If this field is null, the base station will not
recognize VLAN tagging or VLAN discovery through DHCP.
Enter the priority level given to packets belonging to the VLAN identified
above. Enter a priority level from 0 to 7.
Important! VLAN Settings are not synchronized with other base
stations in a multi cell chain. If you change the VLAN
Settings, you must change them on each base station.
• Select Enable to use SIP server (IPedge or
Strata CIX system) option 120 to obtain the SIP
Server's IP address in the DHCP response. (To
enable this feature, Option 120 with the SIP
server IP address must be configured on the
DHCP server.)
• Select Disable to not use SIP server option 120.
Select Enabled if you want the system to use RPORT in SIP
messages. This will also cause the base stations to send
Keep Alive messages according to the Keep Alive time.
Otherwise, leave this feature Disabled.
Enter the number of seconds (as a positive integer) between
each keep-alive message sent to maintain NAT address
assignments. The default value is 90.
Description
Description
Description
Network Screen
3-9