Network Screen - Toshiba IP4100 Installation Manual

BASE STATION CONFIGURATION

Network Screen

Figure 3-2 Network Screen
Table 3-8 IP Settings Parameters
Parameter
DHCP/Static IP
IP Address
Subnet Mask
Default Gateway
DNS
(Primary and Secondary)
3-8
Select whether this base station gets its IP address from a DHCP
server or uses a static IP address. Static address is recommended.
(static IP address only) Enter the 32-bit IP address this base station
should use.
(static IP address only) Enter the 32-bit mask to specify which part of
the IP address identifies the network (255) and which part identifies
the node (0). Class A, B, and C networks use the following default
masks:
• Class A: 255.0.0.0
• Class B: 255.255.0.0
• Class C: 255.255.255.0
(static IP address only) Enter the IP address of the router that acts
as an entrance to the network or provides a default route for
communicating with hosts on remote networks.
(static IP address only) Enter the IP addresses of the main (primary)
and backup (secondary) servers where this base station should
direct Domain Name System (DNS) queries.
Description
IP4100 Install Sept., 2013

Network Screen