Table of Contents
Advertisement
B
CM35
To distinguish the maximum number of digits
received from ISDN for each trunk route, spec-
ify an Area Code Development Pattern number
to each trunk route number.
[Series 3200 R6.2 software required]
Provide the ETSI ISDN Overlap Receiving
feature for each trunk route.
[Series 3200 R6.2 software required]
CM85
Specify the maximum number of digits to be
dialed by calling party.
The maximum number of digits including the
area codes should be assigned to each area
code.
CM08
Specify whether the system connects to the
calling party when the system does not receive
the following DID number within the time set
by CM41 Y=0>109, after the first DID number
of the calling party is received.
[Series 3200 R6.2 software required]
Specify whether the system connects to the
calling party when the DID number of digits
received from ISDN is more than the maxi-
mum number of digits assigned by CM85
Y=0-7.
[Series 3200 R6.2 software required]
CM41
Specify the ORT timer for ETSI ISDN Overlap
Receiving.
[Series 3300 software required]
C
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=202
(1)
00-63: B channel Trunk Route No.
(2)
00-07: Area Code Development Pattern
No. 0-7
15
: Not used
•
Y=203
(1)
00-63: B channel Trunk Route No.
(2)
0 : To provide
1 : Not provided
•
Y=0-7 Area Code Development Pattern
No. 0-7 assigned by CM8A
Y=A000
(1)
X-X...X: Area Code dialed, Maximum 8
(2)
01-24 : 1 digit-24 digits
25-79 : 25 digits-79 digits
(1)
626
(2)
0 : Not connected
1 : To connect
(1)
627
(2)
0 : Not connected
1 : To connect
•
Y=0
(1)
109
(2)
03-99: 3-99 seconds
(1 second increments)
If no data is set, the default setting is 6 seconds.
– 150 –
ISDN FEATURE PROGRAMMING
DATA
digits
NWA-008852-001 Rev.5.0
NOVEMBER/15/2006
98ch3001.fm
Advertisement
Table of Contents
