Table of Contents
Advertisement
D
CM35
NOTE:
We recommend the point-to-point
connection when connecting the sys-
tem to the public network using the
BRT card. For the point-to-multi-
point connection using the BRT
card, when the system is established
far from the public network, the
communication error occurs easily
because the ISDN signal fades
away.
Allow sending extension information of Low
layer Compatibility (LLC) information ele-
ment, to each trunk route.
[Series 3200 R6.2 software required]
Specify the method of Layer 1 activation.
Specify whether the ISDN trunk is released
when the system receives ISDN DISCON-
NECT message with Progress Description=08
from ISDN (effective for an outgoing call).
[Series 3200 R6.2 software required]
NOTE:
When sending the in-band tone to
the calling station from ISDN, set
the second data to 1.
In this case, the ISDN trunk will be
released automatically in 30 sec-
onds after the calling station re-
ceives the in-band tone or when the
calling station goes on-hook.
E
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=39 Trunk release by detection of rever-
sal of tip and ring
(1)
00-63: B channel Trunk Route No.
(2)
1 : To release
• Y=79 Terminal connection form for ISDN
Basic Rate Interface
(1)
00-63: B channel Trunk Route No.
(2)
0 : Point-to-Point
1 : Point-to-Multipoint
•
Y=90 Assignment of BRT route for ISDN
(1)
00-63: B channel Trunk Route No.
(2)
2: ISDN-Basic Rate Interface
•
Y=130
(1)
00-63: B channel Trunk Route No.
(2)
0: Allow
•
Y=144
(1)
00-63: B channel Trunk Route No.
(2)
0 : Activated by call event
1 : Always activated
•
Y=158
(1)
00-63: B channel Trunk Route No.
(2)
0 : To release
1 : Not released
– 108 –
ISDN-BRI PROGRAMMING
DATA
BRT INITIAL
BRT INITIAL
NWA-008852-001 Rev.5.0
98ch3001.fm
NOVEMBER/15/2006
Advertisement
Table of Contents
