Table of Contents
Advertisement
CPN to Terminating User-Display
[North America]
To provide Calling Name Display for incoming calls from National ISDN 2/NTI (DMS100), assign the
following programming.
START
CM12
Assign Service Restriction Class A to each sta-
tion.
CM15
Allow Calling Name Display for incoming
calls in Service Restriction Class A assigned
by CM12 Y=02.
Specify the displaying pattern of Caller ID on
the LCD of D
swering a trunk call.
[Series 3800 software required]
NOTE 1:
NOTE 2:
CM08
Specify the duration of displaying the name
when the incoming call is answered/the select
key for Calling Number Display and Calling
Name Display or CID key is pressed.
[Series 3300/3400/3500/3600 software
required]
NOTE:
A
DESCRIPTION
term
before answering or after an-
When the second data of CM15
Y=400 is set to 0, set the second
data of CM15 Y=136 to 1 (Calling
Name Display).
When the second data of CM15
Y=400 is set to 1, set the second
data of CM15 Y=136 to 0 (Calling
Number Display).
When using Series 3700 R12.2 soft-
ware or later, set the first data to
580.
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=02
(1)
X-XXXXXXXX: Station No.
(2)
XX ZZ
XX: 00-15 : Service Restriction Class A
•
Y=136
(1)
00-15: Service Restriction Class A
(2)
1 : Calling Name Display
•
Y=400
(1)
00-15: Service Restriction Class A
(2)
0 : To display Calling No. on upper line of
LCD, Calling Name on middle line of
LCD
1 : To display Calling Name on upper line
of LCD, Calling No. on middle line of
LCD
7 : Not displayed Calling No. and Calling
Name simultaneously
(1)
537
(2)
0 : Until call is finished/key is pressed
again
1 : 6 seconds
– 131 –
ISDN FEATURE PROGRAMMING
DATA
assigned by CM12 Y=02
assigned by CM12 Y=02
NWA-008852-001 Rev.5.0
98ch3001.fm
JULY/13/2007
Advertisement
Table of Contents
