Panasonic DBS576 Section 700 Technical Manual page 153

Section 700 - Operation
• 3 extensions
• 2 extensions and 1 CO line
• 1 extension and 2 CO lines
Operation
To establish a conference call:
1. While on a call, press the HOLD key or the line key of your
current call.
2. If adding an outside party, press a vacant CO key, or dial a
trunk access code.
3. Dial the number of the party you wish to add to the call.
4. Press the CONF key when your call is answered.
5. To add additional parties, repeat steps 1-4
6. For 3-party Conference Call Only:
To release a conference member, press PROG + 1 to release
conference member 1 or press PROG + 2 to release confer-
ence member 2, etc.
Note: The conference member numbers are shown on the
display.
7. To drop out of the conference call, hang up.
To establish a two-party private conversation from a 3-party conference (Version 2.1
and higher):
1. While on a call, press the CONF + 1 (2) to have a private
conversation with the CNF 1 (2) party as shown on the dis-
play.
2. To reestablish the conference, press the CONF key.
576-20-700
Action
Action
DBS 576 (USA), issued January 1999
Chapter 5. Key Telephone Features
Result
Extension number, outside line number,
or name of held party displays
• Outside dial tone
• CO #XXX displays (where XXX = line
number)
Dialed number displays
CNF1:CO XXX or EXT XXX and
CNF2:CO YYY or EXT YYY displays
(where XXX = first party and YYY = sec-
ond party)
(Available up to 3-party conference. Not
available for 4-party or more conferenc-
ing)
(See **Considerations below)
Result
You and the selected party are in a sepa-
rate conversation from the other confer-
ence parties.
CNF1:CO XXX or EXT XXX and
CNF2:CO YYY or EXT YYY displays
(where XXX = first party and YYY = sec-
ond party)
153