6.1
Troubleshooting
PROBLEM
During a power interrup-
tion, extensions connected
to jack numbers 1, 2, 9, 10
for KX-TD816, and 1, 2, 9,
10, 17, 18 for KX-TD1232
do not operate.
During system connection
operation for KX-TD1232,
originating an intercom/
CO call from a system to
the other system is not
possible.
Originating a CO call, Call
Transfer, or Conference
cannot be performed.
6.1.4
Using Reset Button
PROBABLE CAUSE
• A DPT or APT is
connected to the jack.
• The dialing mode (tone or
pulse) is improper.
Interface between the
systems is disconnected.
The corresponding CO
button does not exist on the
proprietary telephone.
If the system does not operate properly, use the Reset Button.
(If Master and Slave Systems are in operation by System
Connection for KX-TD1232, reset both systems.)
Before using the Reset Button, try the system feature again to
confirm whether there definitely is a problem or not.
Notes:
(a) When the System Clear Switch is set to "NORMAL," pressing
the Reset Button causes the following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
Other data stored in memory except the above are not cleared.
(b) When the System Clear Switch is set to the "CLEAR" position,
you must press the Reset Button with caution, because all data
stored in memory will be cleared by the following operation:
pressing the Reset Button and setting the System Clear Switch
to the " NORMAL" position while the Power Indicator is
flashing.
POSSIBLE SOLUTION
• Disconnect the DPT or APT and
connect a single line telephone.
• Set the Tone / Pulse switch to the
other position.
Connect the interface between the
systems and press the Reset Button
on both systems.
Program the CO button. See
Section 4.2 [005] "Flexible CO
Button Assignment."
Troubleshooting
6-5