Upper case, steering arm, swivel bracket and clamp brackets
Removing the clamp brackets
1. Remove the self-locking nut 1 and
ground lead 2, then clamp brackets 3
and 4.
2. Remove the trim sensor 5.
Installing the clamp brackets
1. Install the trim sensor 1 onto the port
clamp bracket.
NOTE:
Adjust the trim sensor after installing the
power trim and tilt unit.
69J1D11
2. Assemble the clamp brackets and the
swivel bracket by connecting the ground
lead 2, installing the through tube 3,
then tightening the self-locking nut 4 fin-
ger tight.
Installing the power trim and tilt unit
1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
NOTE:
After tilting up the outboard motor, be sure to
support it with the tilt stop lever.
2. Install the bolts 2 onto both clamp
brackets together with the power trim and
tilt unit 3.
1
2
3
4
5
6
7
8
9
7-18