Replacing The Timing Belt - Yamaha F200C Service Manual

POWR
35. Install the ignition coil cover, wiring har-
ness guide, and flywheel magnet cover.

Replacing the timing belt

1. Remove the flywheel magnet cover, igni-
tion coil cover, and intake silencer.
2. Turn the flywheel magnet clockwise and
align the "1TDC" mark a on the flywheel
magnet with the pointer b, and check
that "I" marks c and d on the driven
sprockets are aligned with marks e and
f.
NOTE:
Do not turn the flywheel magnet counter-
clockwise.
3. Remove the flywheel magnet.
È
5-21
Power unit
È
CAUTION:
• Apply force in the direction of the
arrows shown, to prevent the flywheel
holder from slipping off easily.
• To prevent damage to the engine or
tools, screw in the flywheel puller set
bolts evenly and completely so that the
flywheel puller plate is parallel to the fly-
wheel magnet.
NOTE:
Apply force to the crankshaft end until the fly-
wheel magnet comes off the tapered portion
of the crankshaft.
Flywheel magnet holder 1:
YB-06139
Universal puller 2: YB-06117
4. Disconnect the ignition coil couplers, idle
speed control coupler, intake air pres-
sure sensor coupler, throttle position
sensor coupler, thermoswitch leads, idle
speed control hose, high-pressure fuel
hoses, neutral switch coupler, shift cut
switch coupler, and starboard fuel injec-
tor couplers.
69J1D11