Installing The Lower Unit - Yamaha F200C Service Manual

5. Install the washers 7, wave washer 8,
spacer 9, and collar 0 to the drive shaft.
NOTE:
• The collar and spacer should fit together
firmly.
• While pulling the drive shaft up, install the
collar with an appropriate tool a that fits
over the drive shaft as shown.
6. Install the O-ring A and insert cartridge
B into the pump housing C.
A
C
c
c
NOTE:
Align the insert cartridge projections b with
the holes c in the pump housing.
7. Install the O-ring D and pump housing
assembly E into the lower case, tighten
the bolts F, and then install the seal G
and cover H.
69J1D11
Drive shaft and lower case (counter rotation model)
A A
b
B
b
4
S69J6310U
LT
572
NOTE:
• When installing the pump housing, apply
grease to the inside of the housing, and
then turn the drive shaft clockwise while
pushing down the pump housing.
• Align the cover projection d with the hole
e in the pump housing.

Installing the lower unit

1. Set the gearshift to the neutral position at
the lower unit.
A A
S69J6315
6-48
1
2
3
4
5
6
7
8
9