Paper Alignment At The Registration Roller - Toshiba e-STUDIO350 Service Handbook

3.2.2

Paper alignment at the registration roller

The aligning amount is adjusted by using the following codes in Adjustment Mode (05).
Paper
Weight
type
Plain
2
64 - 80 g/m
paper
17 - 20 lb.
Thick 2
81 - 105 g/m
paper 1
21 - 28 lb.
Thick
106 - 163 g/m
paper 2
29 - 43 lb.
Thick
164 - 209 g/m
paper 3
44 - 55 lb.
OHP -
Sub-code
*1 0: Long size
*2 0: Long size
*3 0: Long size of OHP film 1: Middle size of OHP film
Notes:
1. Long size: 330 mm or longer (13.0 inches or longer)
Middle size: 220 - 239 mm (8.7 - 12.9 inches)
Short size: 219 mm or shorter (8.6 inches or shorter)
2. The adjustment of "Post card" is for Japan only.
<Procedure>
(1) Perform the test print according to the following procedure.
[0][5]
(Code) [START]
[Power]
[SET] or
[INTERRUPT]
Stores in memory
(*4) 1: Single-sided grid pattern 3: Double-sided grid pattern
(2) Check if any transfer void is occurring. If
there is a transfer problem, try the values in
descending order as "31" → "30" → "29"···
until the transfer void disappears. At the
same time, confirm if any paper jam occurs.
Also, when the aligning amount has been
increased, this may increase the scraping
noise caused by the paper and the Mylar
sheet as it is transported by the registration
roller. If this scraping noise is annoying, try to
decrease the value.
(3) Perform the same procedure for all paper sources.
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Upper Lower
drawer drawer
450 (*1) 452 (*1)
469 (*1) 470 (*1)
- -
2
2 - -
- -
1: Middle size
1: Middle size
(Not necessary for LCF)
(Sub-code) [START]
[Drawer
selection]
3 - 5
PPP PPP
upper lower LCF
drawer drawer
448 (*1) 449 (*1) 457
471 (*1) 472 (*1) 473
- - -
- - -
- - -
2: Short size
2: Short size
2: Short size of OHP film
Current value
displayed
(*3) +[FAX]
(Test print)
Transfer void
Fig. 3-1
Bypass
ADU
feed
455 (*1) 458 (*1)
474 (*1) 460 (*1)
- 461 (*1)
- 462 (*2)
- 463 (*3)
3: Post card
Enter new
value
[POWER]
OFF/ON
(Exit)
e-STUDIO350/352/353/450/452/453
ADJUSTMENT
3