Chapter 2
Setup for the IM-800 and the DM-M820
Setting the AC Voltage for the IM-800 (For the Standard model)
If you are using 100-127 V power, set the AC
voltage switch to 115. If you are using 200-240 V
power, set the AC voltage switch to 230. (The
factory setting is 230.) If the setting is wrong,
the system will be damaged and will not
operate.
Follow these steps:
1. Remove the warning sheet.
2. Set the AC voltage select switch.
IM-800 Installation Positions
You can install the unit in either of the positions shown.
The rubber feet are used only when the unit is installed
horizontally. Attach the rubber feet to the indentations on
the bottom of the unit.
WARNING:
If you set this product upright, be sure the ventilation opening is on the top. Do not place
any object on top of the ventilation opening. If the ventilation opening is blocked, the
product can be damaged by overheating.
If you install this product horizontally, never place any object within 3 cm {1.2"} of the
ventilation openings on the front, side, and rear. If the ventilation opening is blocked,
the product can be damaged by overheating.
Rev. I
MR Series Technical Reference Manual
Setup for the IM-800 and the DM-M820 2-1