Errors While Scanning; Symbology Parameter Defaults - Motorola RS507-IM2xxxxSTWR Product Reference Manual

6 - 2 RS507 Hands-Free Imager Product Reference Guide
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes. See the individual
parameter, such as Set Length(s) for D 2 of 5, for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Symbology Parameter Defaults

Table 6-1 lists the defaults for all symbology parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers appear in this
chapter below the parameter title, and options appear in parenthesis beneath the accompanying bar codes.
Refer to the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing
parameters using this method.
NOTE See
parameters.
Parameter Defaults
Table 6-1
UPC/EAN
UPC-A
UPC-E
UPC-E1
EAN-8/JAN 8
EAN-13/JAN 13
Bookland EAN
Decode UPC/EAN/JAN Supplementals (2 and 5 digits)
User-Programmable Supplementals
Supplemental 1:
Supplemental 2:
UPC/EAN/JAN Supplemental Redundancy
Decode UPC/EAN/JAN Supplemental AIM ID
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Appendix A, Standard Default Parameters
Parameter
Set Default Parameter on page
for all user preferences, hosts, and miscellaneous default
Parameter
Default
Number
01h Enabled
02h Enabled
0Ch Disabled
04h Enabled
03h Enabled
53h Disabled
10h Ignore
F1h 43h
F1h 44h
50h 10
F1h A0h Combined
28h Enabled
29h Enabled
5-4.
Page
Number
6-7
6-7
6-8
6-8
6-9
6-9
6-11
6-13
6-13
6-14
6-14
6-14