Siemens HiPath 2000 Administration Manual page 86

Alphabetical Reference
QCU Home Address
•
•
QDC Server
•
•
QoS L2/L3
•
•
•
•
RAM Test
•
•
Report Interval
•
•
•
•
Report Mode
•
86
Enter the IP Address of the QCU server on which the QoS data is
logged.
Default value Page 109.
Page 64
Enter the Port number for communication with the QDC server.
Default value Page 109.
Page 66
The settings relate to the
QoS, which regulate the prioritization of the transferred data.
For Layer 2, the L2/L3 Voice/Signaling and the
changed. For Layer 3, the
The activation of Layer 2 and / or Layer 3 support is meaningful only if
the Switch used can interpret this information (e.g. "Layer 2
Switch").
Default value Page 109.
Page 24 Page 63
You can test the
The results are displayed after the test is over.
Page 33 Page 59
Time interval (in sec.) in which reports are sent.
A QoS report is sent for each report interval if the
set accordingly.
Valid values: 10 ... 3600.
Default value Page 109.
Page 64
Choose the relevant report mode:
– 1: A report will be sent at the end of a session and only if the
threshold has been reached.
– 2: A report will be sent within each
has been reached.
– 3: A report will always be sent at the end of a session.
– 4: A report will always be sent within each
Page 64
Layer 2 and
L2/L3 Voice/Signaling can be changed.
RAM memory of your optiPoint 410/420.
Layer 3 areas of the
L2 Default can be
Report Mode was
Report Interval if the threshold
Report Interval.