Yamaha MT-01 T 2005 Service Manual page 47

Item
Crankshaft:
Connecting rod bolt (1st)
Connecting rod bolt (final)
Chain drive:
Drive sprocket cover bolt
Drive chain guide bolt (drive
sprocket side)
Drive sprocket nut
Fuel injection system
(surrounding parts):
Throttle body joint clamp screw
Throttle position sensor screw
Intake manifold assembly bolt
Injector joint screw
Fuel pipe bolt
ISC (idle speed control) unit bolt
Others:
Rectifier/regulator bolt
Horn nut
EXUP servo motor bracket bolt
EXUP servo motor bolt
NOTE:
• Tighten the connecting rod bolts to 15 Nm (1.5 m·kg, 11 ft·lb), and then tighten them further to reach
the specified angle 120°–150°.
• Install the crankcase stud bolts (M12) so that their installed length is 217.5 mm (8.56 in).
• Install the crankcase stud bolts (M10) so that their installed length is 141.5 mm (5.57 in).
Thread
Q'ty
size
M8 4
M8 4 Specified angle 120°–150°
M6 3 10 Nm (1.0 m·kg, 7.2 ft·lb)
M8 3
M22 1
M4 2
M5 2
M6 4 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 4
M12 2
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 2
M6 1
M6 2
M6 1
2-21
TIGHTENING TORQUES
Tightening torque
15 Nm (1.5 m·kg, 11 ft·lb)
24 Nm (2.4 m·kg, 17 ft·lb)
95 Nm (9.5 m·kg, 68 ft·lb)
4 Nm (0.4 m·kg, 2.9 ft·lb)
5 Nm (0.5 m·kg, 3.6 ft·lb)
5 Nm (0.5 m·kg, 3.6 ft·lb)
30 Nm (3.0 m·kg, 22 ft·lb)
7 Nm (0.7 m·kg, 5.1 ft·lb)
7 Nm (0.7 m·kg, 5.1 ft·lb)
7 Nm (0.7 m·kg, 5.1 ft·lb)
7 Nm (0.7 m·kg, 5.1 ft·lb)
Remarks
See
NOTE.
M
See
NOTE.
M
LT
Stake
E