Installing The Rear Shock Absorber Assembly - Yamaha MT-01 T 2005 Service Manual

Relay arm nut (relay arm and
connecting arm)
49 Nm (4.9 m·kg, 35 ft·lb)
EAS23310
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY
1. Lubricate:
• Spacers
• Bearings
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Relay arm
(to the swingarm)
NOTE:
When installing the relay arm, lift up the swing-
arm.
3. Tighten:
• Rear shock absorber assembly nut (front
side)
Rear shock absorber assembly
nut (front side)
49 Nm (4.9 m·kg, 35 ft·lb)
• Relay arm nut (relay arm and swingarm)
Relay arm nut (relay arm and
swingarm)
40 Nm (4.0 m·kg, 29 ft·lb)
4. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE CHAIN
SLACK" on page 3-24.
Drive chain slack
40.0–50.0 mm (1.57–1.97 in)
REAR SHOCK ABSORBER ASSEMBLY
4-64