Sony DFS-700 Service Manual page 28

Selecting Images
Switching the internal video signal selected by the INT VIDEO button
To switch the internal video signal selected by pressing the INT VIDEO
button on either the background bus or foreground bus, use the following
procedure.
EDITOR
GPI
SET UP
SHIFT
1
AUXILIARY
BLACK
BACKGROUND
BLACK
FOREGROUND
BLACK
1
Press the MATTES button in the menu control section.
Page 1 of the MATTE menu appears.
2
Press the PAGE button in the effect control section, to display page 2
of the MATTE menu, then press the F4(INTVID) button to select the
desired signal.
MATTE
2/2
PAGE
You can select any of the following three possibilities.
Matte: color background signal. In the following step 3, you can select
any of plain, or 79 different embossed patterns.
You can adjust the color of the color background signal as desired. For
details, see the section "Adjusting Color Mattes" (page 3-57).
Bar: color bars
Grid: a grid pattern
3
If you have selected a color background signal carry out either of the
following.
• Hold down the INT VIDEO button in the background bus or
foreground bus, and in the pattern/numeric keypad press the UP or
DOWN button.
Each time you press, the pattern changes, and the new pattern appears
on the program monitor.
• Turn the F5(PTN) knob.
3-14
Chapter 3 Basic Operation
3
USER PGM SNAP SHOT
1 TITLE 2 DSK EDGE
STATUS EDIT
LUM LUM LUM TRAIL
SHADOW
CRK CRK BORDER BEVELD
EDGE
INITIAL EDIT LEARN
2
MASK MASK MASK SOFT
RECALL
CCR LIGHTING MATTES BORDER PATTERN PAGE F1 F2 F3 F4 F5 LOCATION
HOLD
ADJ INPUT
EFFECT
TRANS RATE DSK PATTERN NUMBER
FTB
SET SET
CCR TITLE 1 TITLE 2 DSK SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT N/R REV DIRECT DIRECT DSK PVW
RECALL PATTERN
SOURCE SOURCE FILL
LAST X FADE
TO
1 2 3 4 5 6 7 8 7 8 9 INS BLACK
MEMORY INT TITLE
VIDEO
4 5 6 DEL
INT
1 2 3 4 5 6 7 8 MEMORY CUT
VIDEO
P IN P
DSK
1 2 3
RST
DOWN UP ENTER
0
INT AUTO
1 2 3 4 5 6 7 8 MEMORY
VIDEO TRANS
PATTERN/KEY PAD
3
FROM TO COPY INTVID PTN
INT V BORD EXEC Matte 1-80
F1 F2 F3 F4 F5
Previewing the image after an effect is executed
Select the background image and foreground image, and set up the effect,
then move the fader lever to the opposite end.
You can now check on the program monitor the result of carrying out the
currently set effect.
If a preview monitor is connected, you can check the foreground image on
the preview monitor.
3-15
Chapter 3 Basic Operation