Sony DFS-700 Service Manual page 19

Control Panel
4 HOLD INPUT button
To hold the primary cross-point bus settings and the
auxiliary bus settings (signal selections) fixed when
recalling a snapshot, press this button. When you press
this button, it lights, and when you recall a snapshot,
the system is in the hold input mode. When you recall
a snapshot in this mode, all settings are recreated on
the control panel except those relating to the primary
cross-point bus and the auxiliary bus.
Press the button once more to turn it off and exit the
hold input mode.
qa Location section
2 Joystick
3 Z-knob
LOCATION
1 LOCATION button
1 LOCATION button
Press this button to use the joystick and Z-knob. When
you press this button, it lights, and enables the joystick
and Z-knob.
Press the button once more to disable the joystick and
Z-knob, and return the effect pattern to its default
position.
Holding down the INITIAL button while pressing this
button returns the setting to its default value.
2 Joystick
Use the joystick to position the effect pattern in the x-
and y-directions.
3 Z-knob
Turn the Z-knob to move an effect pattern in the depth
direction (the z-axis). With this you can change the
effective size of the pattern.
2-12
Chapter 2 Location and Function of Parts and Controls
qs 25-pin connector (rear panel)
Use the supplied 25-pin control cable to connect this to
the PANEL connector on the processor unit.
Processor Unit
Front Panel
Power indicator
Power switch
Power switch and indicator
This powers the unit on and off. Press the " " side of
the switch to power on, and the " " side to power off.
When the power is on, the power indicator lights
amber.
Rear Panel
1 PGM OUT connectors
2 VIDEO INPUT connectors
DIGITAL I/O ANALOG I/O
PGM OUT SDI INPUT PGM OUT VIDEO INPUT
COMPONENT COMPONENT/COMPOSITE COMPONENT
OPTION COMPOSITE
(OPTION)
1 5 1 1 2 1 8 7 6 5 8/4 7/3
Y Y/V
2 R-Y R-Y
2 6 2
B-Y B-Y
PVW
7 3
CLEAN
OUT
8 4 S VIDEO S VIDEO REF.VIDEO IN
2 1 8 7 (OPTION) 6 5
DSK KEY IN
BLACK BURST OUT
3 2 1
q; DSK KEY IN connectors
and 75Ω terminator
switch
9 BLACK BURST OUT 1 to 3
connectors
8 PVW connector
7 CLEAN OUT connector
4 PANEL connector
5 TALLY connector
6 TERMINAL connector
3 EDITOR
connector
PANEL
6/2 5/1
Y
TALLY
R-Y
B-Y TERMINAL
EDITOR
GPI/T
ON 2 1
75Ω
OFF
AC IN
ON
75Ω
OFF
qf - AC IN connector
qd U terminal
qs GPI/T 1 and 2 connectors
qa REF. VIDEO IN connectors and 75Ω
terminator switch
2-13
Chapter 2 Location and Function of Parts and Controls