Contacts; Contact Inputs; Relay Outputs; Contact Input Properties - Bosch Divar 700 Series Installation And Operation Manual

78 en | Advanced configuration
6.5

Contacts

Use the Contacts menu to set up alarm inputs and relay outputs.
Figure 6.11 Configuration menu - Contacts
6.5.1

Contact inputs

By default, all contact Inputs are Normally Open (NO). When needed, highlight contact inputs
to function as Normally Closed (NC) contacts (highlight the un-numbered box to select all).
Note:
If an IP camera is attached to the unit, physical contact input 1 of the IP camera is ORed with
the similarly numbered physical contact input. This ORed level is used as alarm or event
source. For example, if camera 3 is an IP camera then its contact input is ORed with the
recorder contact input number 3. Contact inputs other than contact 1 are ignored by the
recorder.
6.5.2

Relay outputs

By default, all relay output contacts are Normally Open (NO). When needed, highlight the relay
outputs to function as Normally Closed (NC) contacts.
Note:
The local interface does not provide control over relay outputs on IP devices.
6.5.3

Contact input properties

Each of the 16 contact inputs can be assigned a name and a profile override mode.
Profile overrides
An alarm input can activate a profile override. There are three modes available:
F.01U.246.471 | v3.4 | 2011.06 Installation and Operation manual
Divar 700 Series
Bosch Security Systems