Advertisement
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS []
Are these
the right instructions
for your
model?
Follow
the Installation
Instructions
indicated
by
the label
on the back of the refrigerator--
[] []
[]
[]
[] []
[]
[] []
[]
[] [] or []
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
•
CAUTION
-
Unplug
the
_
Refrigerator.
To eliminate
the danger
of electric
shock during
installation,
_,
you must unplug
the refrigerator
from its electrical
outlet.
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
screwdrivers
Sharpknife
1/4" and5/16" Nutdrivers
ffIREMOVE
THE COVER
Remove
the screws holding
the left side of the
compressor
cover and save them for reinstallation
later. Bend the cover back to access the
compartment.
[]
ATTACH THE WATER VALVE
• Locate
the female
connector
plug (B). If there
are 2 female connectors,
use the colored
one.
Plug the female connector
(B) onto the male
terminals
on the water valve (4). Either wire
can go on either terminal.
o U_
• Fasten
the water valve to the cabinet
by inserting
the bracket hook on the left inner
side of the
compressor
compartment.
Drive the hex-head
screw (13) from the kit through
the hole in the
bracket
into the hole on the cabinet.
[] INSTALL WATER LINE CLAMP
• Attach
the water line clamp (strain
relief) (8) from
the kit to the refrigerator.
With the clamp directly
in line with the water valve, drive the screw (7)
from the kit through
the clamp(8)
at the indent
into the back of the cabinet.
• The metal clamp is for the house water line (see
Water Line Installation
Instructions).
It is not to
be used for the tubing
from the water valve up to
the icemaker.
48
Advertisement
