Advertisement
Installation Instructions
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly
before
proceeding.
" CAUTION-
Unplug
the
_
Refrigerator.
To eliminate
the danger
in
of electric
shock during
installation,
you must unplug
the refrigerator
from its electrical
outlet.
[] A1-FACH THE WATER VALVE
• Locate the female connector
plug (C).
TOOLS YOU WILL NEED
Flatblade andPhillips
Pliers
Sharpknife
screwdrivers
1/4" and5/16" Nutdrivers
Tape measure
I_REMOVE
THE COVER
At the bottom
rear of the refrigerator,
remove
the
screws holding
the access cover.
Bend the cover back to access the compartment.
Be sure to save the screws as the access cover must
be reinstalled
later to ensure
that )'our refrigerator
will function
properly.
• Plug the female connector
(C) onto the male
terminals
on the water valve (3). Either
wire
can go on either terminal.
• Fasten the water valve to the cabinet
by driving
the hex-head
screw (8) from the kit into the
hole in the cabinet
leg.
Cabinet
_=m_i
ew
[] CUT PLASTIC WATER TUBING
• Measure
25" (64 cm) of water tubing starting
from where it is secured
to the water valve.
Cut off excess tubing with a sharp knife or
single-edge
razor blade.
25" (64 cm)
5
Advertisement
