Configuring The L3 Tunnel Network; Example Of Configuring L3 Roaming By Using The Cli - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
C L3 T
ONFIGURING THE
Configure L3 tunneling by modifying or adding a Network. Then, make sure the network is associated with a VAP on the AP
Profile assigned to the APs that wireless clients might use for roaming. Once you change the AP Profile, re-apply the profile
to the APs to reset the APs that use the profile.
Note: When L3 tunneling is enabled, the VLAN ID for the network is not used. In fact, the switch puts the
management VLAN ID, if any, on the tunneled packets.
In this example, the L3 Tunnel network is on Network 3 on the Default AP Profile. The SSID of the network is "L3 Tunnel,"
and the security mechanism is WPA Enterprise.

Example of Configuring L3 Roaming by Using the CLI

The following procedures show how to configure the D-Link Unified Switch by using the CLI. The Web interface configuration
procedures follow this example.
1 Enter the network configuration mode for network 3.
(switch-prompt) #configure
(switch-prompt) (Config)#wireless
(switch-prompt) (Config-wireless)#network 3
2 Create the network name (SSID).
(switch-prompt) (Config-network)#ssid "L3 Tunnel"
3 Configure security on the network to control wireless client access.
For this network, the administrator uses WPA Enterprise for the security mode. The administrator must also configure
the security on each client that is allowed to access the L3 Tunnel network.
(switch-prompt) (Config-network)#security mode wpa-enterprise
4 Enable L3 roaming.
(switch-prompt) (Config-network)#tunnel
5 Configure the L3 network IP address and subnet mask for the tunnel.
Note: The network address you enter must be the same subnet used by the VLAN routing interface created in
"Creating the VLAN Routing Interface" on page
(switch-prompt) (Config-network)#tunnel subnet 192.168.60.0 mask 255.255.255.0
6 Exit out of Network mode and Enter AP profile configuration mode for the default profile (Profile 1).
(switch-prompt) (Config-network)#exit
(switch-prompt) (Config-wireless)#ap profile 1
7 Enter the AP Profile Radio Config mode for the radio you want to use.
In this example, the L3 Tunnel network uses Radio 1, which is the 802.11g radio by default.
(switch-prompt) (Config-ap-profile)#radio 1
8 Enter the AP Profile VAP Config mode for VAP 2 and enable the VAP.
Page 218
N
UNNEL ETWORK
215.
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10