Table 34: Managed Ap Neighbor Status - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
Field
Manual Power
Adjustment Status
Total Neighbors
Use the buttons at the bottom of the page to perform the following tasks:
• Click Refresh to update the screen with the most current information.
• Click Back to see the Radio Summary.
Viewing Managed Access Point Neighbor APs
During the RF scan, an access point collects and stores beacon information visible from neighboring access points. Access
points can store the neighbor information for up to 64 neighbor APs. If the neighbor scan information exceeds the capacity
the oldest data in the neighbor list is overwritten.
• The Delete All Neighbors button clears the list. The list is repopulated as neighbors are discovered.
• Click Refresh to update the screen with the most current information.
Table 34 describes the fields you see on the Neighbor APs page for the managed access point status.
Field
MAC Address -Location
(Menu)
Radio
(ex. 1-802.11g)
Neighbor AP MAC
SSID
RSSI
Status
Document 34CS3000-SWUM104-D10
Table 33: Managed AP Radio Detail
Description
Indicates the current state of a manual request to change the power setting on this radio. The
valid values are:
• None - No request has been made to change the power.
• Requested - A power adjustment has been requested by the user but has not been
processed by the switch.
• In Progress - The switch is processing a power adjustment request for this radio.
• Success - A power adjustment request is complete.
• Failure - A power adjustment request failed.
Total number of neighbors (both APs and clients) that can be seen by this radio in its RF area.

Table 34: Managed AP Neighbor Status

Description
Shows the MAC address and location of the AP to which the values on the page apply. To
view details about a different AP, select its MAC address from the menu.
Indicates a radio interface and its configured mode. Select one of the radios to view the
neighbor APs detected via an RF scan on that radio.
The Ethernet MAC address of the neighbor AP network, this could be a physical radio
interface or VAP MAC address. For D-Link Access Points this is always a VAP MAC address.
The neighbor AP MAC address may be cross-referenced in the RF Scan status.
Service Set ID of the neighbor AP network.
Received signal strength indication, this is an indicator of the signal strength relative to the
neighbor and may give an idea of the neighbor's distance from the managed AP.
Indicates the managed status of the AP, whether this is a valid AP known to the switch or a
Rogue on the network. The valid values are:
• WS Managed - The neighbor AP is managed by this switch, the neighbor AP status can be
referenced using its base MAC address.
• Peer WS Managed - The neighbor AP is managed by another switch within the peer group.
• Acknowledged Rogue - The AP is configured as a valid AP entry (local or RADIUS), it has
been acknowledged and is not reported as Rogue.
• Ad Hoc Rogue - The AP neighbor was detected participating in an ad hoc network.
D-Link Unified Access System
Page 131