Software User Manual
02/15/2011
Configuring Global Settings
The fields on the Administration > Advanced Configuration > Global > General tab are settings that apply to the D-Link
Unified Switch.
Table 58
describes the fields on the Wireless Global Configuration page.
Field
Peer Group ID
Client Roam Timeout
Ad Hoc Client Status
AP Failure Status
Client Failure Status
RF Scan Status
Document
34CS3000-SWUM104-D10
Figure 74: Global Configuration
Table 58: General Global Configurations
Description
In order to support larger networks, you can configure Unified Switches as peers, with up to 4
switches in a peer group. Peer Unified Switches share some information about APs and allow
L3 roaming among them.
Peer Unified Switches are grouped according to the Group ID.
This value determines how long to keep an entry in the Associated Client Status list after a
client has disassociated. Each entry in the status list shows an age, and when the age reaches
the value you configure in the timeout field, the entry is deleted.
This value determines how long to keep an entry in the Ad Hoc Client Status list. Each entry
in the status list shows an age, and when the age reaches the value you configure in the
timeout field, the entry is deleted.
This value determines how long to keep an entry in the AP Authentication Failure Status list.
Each entry in the status list shows an age, and when the age reaches the value you configure
in the timeout field, the entry is deleted.
This value determines how long to keep an entry in the Client Authentication Failure Status
list. Each entry in the status list shows an age, and when the age reaches the value you
configure in the timeout field, the entry is deleted.
This value determines how long to keep an entry in the RF Scan Status list. Each entry in the
status list shows an age, and when the age reaches the value you configure in the timeout
field, the entry is deleted.
D-Link Unified Access System
Page 157