Table of Contents
Advertisement
6-2 Channels Section Panels
6-26
Chapter 6 Technical Descriptions
SOURCE section
3 8 Character Display
Indicates signal source point in channel chain from where the signal to
feed the Multitrack is derived.
+/- Push-buttons allow selection of the junction in channel path from
where the Multitrack signal is sourced. The signal will be taken directly
from the ouput of the function displayed.
Note:
Operable only if the IN button for the Multitrack (displayed as MULTI) is not
selected on the Input Channel & Inserts panel.
INSERT section
4 +/- Push-Buttons (Not operational in this version)
Allow the list of insertable devices to be displayed, one at a time, on the 8
character display.
5 INSERT IN Push-Button
Inserts the device selected via the I/O GUI (see Chapter 5).
Note:
It is not possible to change insert selection when the INSERT IN is selected.
Multitrack LEVEL and Pan section
6 LEVEL Knob
Controls the level of signal being sent to the M/T routing bus switching.
7 AFL Push-Button
Sends the signal post the M/T Level to monitor LS.
8 CUT Push-Button
Mutes the signal post M/T Level control.
9 PAN IN Push-Button
Switches in the Pan functionality according to format selected (Stereo or
Multi-Format selected in the centre section). For stereo panning, at least
one odd and one even track must be selected in the Multitrack routing
section.
0 L/R PAN Knob
Allows left/right panning.
Advertisement
Table of Contents
