Table of Contents
Advertisement
Routing and monitoring a signal
Once the set-up operations described earlier in this section have been
completed:
1
Select {M/T SEND} on the SELECT TO FADERS panel and adjust
faders on source channels to suitable level settings.
2
Select suitable destinations for the source channels using the MULTI-
FORMAT routing buttons.
3
Monitor the levels visually on the meters related to the channels set up
as Multi-Format Masters.
4
Listen to the mix via the Multi-Format Monitor described previously in
4-13-2.
Sub Level
The level control for signals sent to the Sub channel works in two modes,
depending on the routing selection.
Routed to SUB only
When the
{SUB}
routing button alone is selected for a channel, the level is
controlled using the M/T Send Fader. Select
TO FADERS panel.
Routed to SUB and other destinations
When the
{SUB}
routing button is selected along with at least one other
routing button for a channel, the level is controlled using the M/T Send
Fader and can be trimmed using the Sub Level Fader. Select
{SUB LEVEL}
accordingly on the SELECT TO FADERS panel.
Note
The setting of the Sub Level Fader will depend upon the sequence of button
presses. If {SUB} is selected first followed by one or more other routing buttons,
the Sub Level Fader will be set at unity gain or 0dB. If {SUB} is selected after one
or more routing buttons, then the Sub Fader will be set at infinity or fully closed.
{M/T SEND}
on the SELECT
{M/T SEND}
4-47
Chapter 4 Signal Paths
or
Advertisement
Table of Contents
