Table of Contents
Advertisement
Configuring a DWX System
Checking the equipment count
Use Wireless Studio to check the type and number of devices connected to the network.
If there are IP address conflicts such as address duplication, the actual number of devices and the number
shown in Wireless Studio will not match.
Procedure
Power up all devices and set Wireless Studio to the online condition. A list of all devices on the network will
be shown.
In cases such as the following, the actual number of devices and the devices shown in the device list
will not match: IP address conflicts, IP address settings with overlapping subnet masks, Ethernet cable
disconnection, device not powered up, etc.
Check the number of DWR-R01D and RMU-01 units in the device list.
Device List window
IP address conflict between DWR-R01D units
The receiver section of the device list will only shown one DWR-R01D unit, so that the count does not match
the actual number of units.
IP address conflict between RMU-01 units
The RMU section of the device list will only shown one RMU-01 unit, so that the count does not match the
actual number of units.
IP address conflict between DWR-R01D and DWR-R01D units
The device list will only shown one device, either in the receiver section or the RMU, so that the count does
not match the actual number of units.
IP address conflict between computer and DWR-R01D, or computer and RMU-01
Wireless Studio cannot be set to the online condition, or the device list does not show the DWR-R01D or RMU-
01, so that the count does not match the actual number of units.
IP address conflict between computers
When the operating system detects an IP address conflict, an alert message will appear on one or both of
the computers.
IP address re-assignment
Check the settings including those for other LANs and network connections as well as the settings within the
same subnet, and verify that there are no IP address conflicts, IP address settings with overlapping subnet
masks, or other problems. If necessary, re-assign IP addresses to the computer, DWR-R01D, and RMU-01 units,
as described in "IP address setup" (page 67).
Note
Wireless Studio identifies the DWR-R01D and RMU-01 by IP address. The DWM-01/DWT-B01 are mutually identified
by the DWR-R01D and MAC address. In order to allow later reloading and complete restoring of setting
information saved in Wireless Studio, all equipment must be the same, and IP address settings also must
match.
70
Making and Checking Network Settings
Advertisement
Table of Contents
