Table of Contents
Advertisement
Configuring a DWX System
Equipment Features
DWX Network Accessories
Remote Control Unit RMU-01
This is a 2.4 GHz antenna designed specifically for Cross Remote
NT mode operation.
By connecting the unit and the DWR-R01D to a LAN, the
transmitter remote control range can be extended, and up to
82 transmitters can be controlled remotely.
Using multiple RMU-01 units to enlarge the service area is also
possible. Up to nine units can be used in one network system.
Power can be supplied either from the included AC adapter or
from a PoE hub supporting PoE (Power Over Ethernet) or a PoE
power supply.
Mounting to a microphone stand is possible.
Bottom side
Hole for attaching the microphone stand
Can be attached to the microphone stand (PF 1/2-inch thread)
with this hole.
To attach an NS 5/8-inch or a W 3/8-inch microphone stand, use
the supplied screw adapter.
AC adapter connector and POWER indicator
Connect the supplied AC adapter to the AC adapter connector
to supply power to this unit.
The POWER indicator lights up green while the power is supplied
from the AC power connector or the LAN connector.
For details on power supply to this unit, see "Power supply (PoE)
for RMU-01".
LAN connector (RJ-45)
This is a 100Base-TX/10Base-T connector for network connection.
Communication speed automatically changes according to the
connected device.
Connect to a receiver such as DWR-R01D, Windows PC, or hub.
When a PoE device including PoE hub is connected, the power is
supplied through this connector.
60
Network System Configuration
The computer on which to install Wireless Studio for use with the
DWX system must meet the following requirements.
The RMU-01 supports PoE (Power over Ethernet).
When the RMU-01 is connected to the LAN using an IEEE802.3af
compliant PoE hub, the RMU-01 can be powered via the LAN
cable.
What is PoE (Power over Ethernet)?
PoE allows powering a device over the Ethernet cables used in
a LAN. Because data and power are routed through a single
cable, installation of equipment is facilitated even in locations
where providing a conventional power supply would be difficult.
The RMU-01 can be powered from an IEEE802.3af compliant hub
with PoE support, or by connecting a PoE power supply between
a regular hub and the RMU-01.
Use Category 5 or better LAN cable for connecting the RMU-01 or
DWR-R01D to the computer. The maximum allowable cable run is
100 meters. If longer cable runs are required, use a hub between
the computer and the RMU-01 or DWR-R01D.
Depending on the connection configuration, use the following
type of cable.
Direct connection to computer: Crossover cable
Connection via hub: Straight cable
Computer requirements
Item
Condition
Windows XP (SP3 or later)
Operating system (OS)
Windows Vista (SP1 or later)
Windows 7 (32 bit/64 bit)
CPU
1 GHz or better recommended
RAM
1 GB or more recommended
Graphics card
Video memory of 128 MB or greater recommended
Available hard disk space
1 GB or more
Monitor resolution
1024 × 768 pixels or better recommended
English-language display capability
Other
100Base-TX LAN card
CD-ROM drive
Ethernet hub information
LAN cable information
Advertisement
Table of Contents
