Sensor Adjustment - Toshiba B-EV4 Series Manual

6. SYSTEM MODE

6.4 SENSOR ADJUSTMENT

Adjust the sensor to the proper position and set the label or tag paper.
When the STATUS lamp lights in red during the system mode, releasing the [FEED] button performs an
auto sensor adjustment and measurement of the label length.
For the details of the sensor adjustment, refer to the Owner's Manual.
6.5 DIAGNOSTIC TEST PRINT/DUMP MODE
When the STATUS lamp lights in green during the system mode, releasing the [FEED] button makes a
Diagnostic Test Print and the printer goes into the dump mode.
Test Print Sample
PRINTER INFO.
PROGRAM VERSION
TONE ADJUST
FEED ADJUST
CUT POSITION ADJUST
BACKFEED ADJUST
PARAMETER
X-COORDINATE ADJUST
SENSOR SELECTION
SENSOR ADJ. VALUE
PRINT SPEED
FLASH ROM
SDRAM
USER MEMORY
TTF AREA
EXT CHAR AREA
BASIC AREA
PC SAVE AREA
INFORMATION
TOTAL FEED
TOTAL PRINT
TOTAL CUT
IP ADDRESS
SUBNET MASK
GATEWAY
MAC ADDRESS
DHCP
DHCP CLIENT ID
SOCKET COMM.
SOCKET COMM. PORT
V1.0C 0A9D
+00
+0.0mm
+0.0mm
+0.0mm
[ PC-850 ] [ 0 ]
[ 9600 ] [ 8 ] [ 1 ] [ NONE ] [ 2 ]
[ ON ] [ AUTO ] [ FEED ] [ B0 ]
+0.0mm
TRANSMISSIVE
TRANSMISSIVE [19] REFLECTIVE [47]
5 IPS
4 MB
8 MB
[ 704 KB][ 0 KB]
[ 0 KB][ 0 KB]
[ 0 KB][ 0 KB]
[ 0 KB][ 0 KB]
[ 704 KB][ 0 KB]
B-EV4-Gx-QM 00000000001
0.0 km
0.0 km
0
192.168.10.20
255.255.255.0
0.0.0.0
00-1B-82-FF-0C-E8
Disabled
FFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFF
Enabled
8000
6-3
EO18-33025
(Revision Date: Mar. 27, 2009)
6.4 SENSOR ADJUSTMENT