3. REPLACING THE IMPORTANT PARTS
3.12 Replacing the Feed Gap Sensor (Lower)
1. Refer to section 3.1 to remove the top cover.
2. Use the Phillips screwdriver to remove the 2 screws from the mylar sheet.
3. Remove the mylar sheet.
Mylar Sheet
4. Remove the sensor connector from the main PC board.
5. Use the Phillips screwdriver to remove the screw from the sensor plate.
6. Remove the sensor plate.
7. Remove the feed gap sensor (lower).
Main PC
Board
Sensor Connector
(JP29)
8. Replace the feed gap sensor (lower) with a new one, then reassemble in the reverse
order of removal.
3.12 Replacing the Feed Gap Sensor (Lower)
3-24
(Revision Date: Mar. 27, 2009)
FLT-3x6 Screw
T-1.5x4 Screw
Sensor plate
Feed Gap Sensor (lower)
EO18-33025