Mitsubishi Electric HD-6000 Owner's Manual page 56

Adding IEEE 1394 Devices Automatically, continued
IEEE 1394 Device Type Screen
Figures 3 and 4
If the new IEEE 1394 device is aHsoconnected using
anaHog inputs, you will need to define the device type.
SeHect the type of device, such as a VCR.
Figure 3. fEEE I394 Device Type screen
Once the device type is seHected, then the Device
screen is dispHayed so the manufacturer can be
seHected. If the manufacturer is Histed, then you may
be aMe to controH this device whiHe it is operating as
an anaHog VCR. For exampHe, if the IEEE 1394 device
you have added is a Mitsubishi DVCR, and you have
seHected an anaHog connection as a second connection,
then you will select Mitsubishi for the manufacturer. If
the manufacturer is not listed, select "Other" and use
the Learn screens.
Be sure to place an IR Emitter in front of the remote
control sensor, just as you have done for other
NetCommand® devices. It is necessary to use the
IR Emitter only when the DVCR is being used as an
S-VHS or VHS VCR. When the DVCR is playing or
recording digital signals in D-VHS, the HDTV receiver/
controller will control the VCR through the IEEE 1394
cable.
Figure 4, Device screen
Connection Screen
Figure 5
Select the HDTV receiver/controller input that you used
when you connected the video or S-Video cables. You
may also select the HDTV receiver/controller or AiV
receiver input you used when you connected the stereo
audio cables. The HDTV receiver/controfler will learn the
input names for the HDTV receiver/controller Input and
AiV Receiver Input selections. If your AiV receiver has
other inputs than those listed in the menu, those other
inputs are not available for NetCommand.
The playback and record control of some DV camcorders
may still operate by the IEEE 1394 cable automatically,
even though you must use the video or S-video cable
for the picture. In this case, when you select the
Camcorder, be sure to select analog (not digital) from the
pop up when a camcorder is selected from the Device
Selection menu. Then the picture is shown via the analog
connection but control is from IEEE 1394.
Figure 5, Connection screen
Finish Screen
Figure 6
To finalize your selections and complete the
NetCommand setup, select Finish from the Finish
screen.
56
Figure 6. Finish screen