Mitsubishi Electric HD-6000 Owner's Manual page 49

Edit NetCommand ® Add Devices, continued
[Device] Screen
Figure 15
If you sebcted "None", during initiai setup, then you
can add a device. If you have added a new device, use
this screen to start baming.
Our exampbs show the choices for adding a VCR,
however, the same type of screens will appear for any
DBS (Direct Broadcast Satellite), DVD piayer or Cabb
Bo-4.
Figure 15. [Device] screen
Choose ONE of these options:
this devbe. Later you may use the "Change" option
in the Setup menu to barn the remote controi
signais.
After sebcfing Next>, the screens that follow are:
the Name Screen (Figure 18), Connection screen
(Figure 19) and speciaiized device screens (Figures
20-23), ending with the Finish screen (Figure 26).
[Device] Learn Screen
Figure 16
Shown only if "Learn" was selected
Sebct a recognized manufacturer. The model
number optimized for NetCommand will display at
the bottom of the screen. If a number follows the
manufacturer's name, (example: Mitsubishi 1), this
indicates additional models are optimized for that
manufacturer. For many device types, non-listed
models will operate in the same way as the listed
models and you can still use the preqoaded setting.
After selecting Next>, the screens that follow are:
the Name Screen (Figure 18), Connection screen
(Figure 19) and specialized device screens (Figures
20-23), ending with the Finish screen (Figure 26).
Select "Other", then highlight "Learn" and press
ENTER. This will allow you to have NetCommand
learn the remote control signals of this new device.
After selecting "Learn" and pressing ENTER, the
screens that follow are: [Device] Learn screen
(Figure 16), [Device] Advanced Learn screen (Figure
17), Name screen (Figure 18), Connection screen,
(Figure 19) and specialized device screens (Figures
20-23), ending with the Finish screen (Figure 26)_
Select "Other", skip Learn and select Next>. This
will allow the device to appear and will allow
NetCommand to switch inputs to use this device.
However, NetCommand will not be able to control
Figure 16. [Device] Learn screen
.
2.
.
.
Press ADJUST A, V, _ or _ to select the check
box for each function to be learned.
Press ENTER and the function name wiii begin to
flash to confirm the ready-to-learn status.
Press the button on the device's remote control
that corresponds to the selected function. A check
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
To test the learned command, press the ENTER
button on the HDTV receiver/controller remote while
the learned function is still highlighted. The device
should perform the selected function. The device
needs to be turned on and the IR emitters properly
placed for the test to be successful (see page 30
for IR emitter placement). If the functions are not
learned the first time, try Learn again.
5. Repeat for each function to be learned.
49