Turning Off The Server - Fujitsu PRIMERGY RX200 S2 User Manual

Chapter 1 Overview

1.4.3 Turning Off the Server

1
Make sure that the floppy disk drive and CD-ROM drives are empty.
2
Shut down the OS.
In the following cases, the server is turned off after the OS is shut down (Step 3 is not necessary).
• Windows OS
• When ServerView is installed
In other cases, shut down the OS and make sure that the floppy disk and hard disk access LEDs
are off.
3
Press the power switch on the front of the server.
The power switch lights amber.
4
Turn off the display and peripheral devices.
The time to turn on/off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server.
For details, refer to "3.2 Settings for Server Monitoring" in "ServerView User's Guide" on the
PRIMERGY Document & Tool CD (Disc 2).
32
• In the event of smoke or sparks, immediately unplug the electric cord. Failure
to do so may lead to a fire or electrocution.
• When turning off the server, be sure to follow the procedures described in this
section. Data can be lost if these procedures are not followed correctly.
• Be sure to wait for 10 seconds or longer after shutdown before turning the
server on.
Otherwise, the server may not start up properly.
Power switch
The servers
power LED is
lit amber