Acer Altos 11000 System User Manual page 80

Onboard Devices Configuration
Onboard Floppy Disk Controller
Onboard IDE Primary Channel .........[Enabled ]
Onboard PS/2 Mouse (IRQ 12) .........[Enabled ]
Onboard USB .........................[Disabled]
USB Legacy Mode ..................[--------]
Onboard SCSI11 ......................[Enabled
Boot from SCSI1 Device ............[Enabled ]
Onboard SCSI2 .......................[Enabled ]
Boot from SCSI2 Device ............[Enabled ]
Onboard Ethernet Chip ...............[Disabled]
Boot from SCSI1 Device ...........[Enabled ]
Onboard SCSI2 .......................[Enabled ]
Boot from SCSI2 Device ...........[Enabled ]
Onboard Ethernet Chip ...............[Enabled ]
= Move Highlight Bar,
PgDn/PgUp = Move Screen
Serial Port 1
This parameter allows you to enable or disable the serial port 1.
Base Address and IRQ items are configurable only if this parameter is
enabled.
This function lets you set a logical base address for serial port 1. The
options are:
3F8h 2F8h
This function lets you assign an interrupt for serial port 1. The options
are IRQ and .
3 4
3-24
......[Enabled Disabled]
Disabled]
= Change Setting, F1 = Help
BASE ADDRESS
3E8h
IRQ
Page 2/2
The
2E8h
User' s Guide