HP D7171A - NetServer - LPr Installation Manual page 71

mount -f ISO9660 -o lower /dev/CDROM_LUN /mnt/cdrom
b
Change to the directory where the hpnapps.tar file is
located, by entering the following command:
cd /mnt/cdrom/periph/nraidadp/openserv/us
c
Copy the file hpnapps.tar to /tmp, by entering the
following command:
cp hpnapps.tar /tmp
d
Change your working directory to /tmp, by entering the
following command:
cd /tmp
e
Untar the archive by entering the following command:
tar -xvf hpnapps.tar
f
Install the UNIX Controller Management Software on your
Openserver system by entering the following command:
pkgadd -d /tmp hpnapps
g
Unmount the cdrom by entering the following command:
umount /mnt/cdrom
UnixWare
a
Place the Navigator cdrom which contains the UNIX
Controller Management Software in the cdrom drive.
The operating system may automount the cdrom on
/mnt/cdrom. If not, do the following:
i
Create the mount point by entering the following
command:
mkdir /mnt/cdrom
ii
Mount the cdrom on /mnt/cdrom by entering a
command like the following, replacing CDROM_LUN
with the logical unit number of your cdrom device (note
that in most cases the default cdrom lun is cdrom1):
mount -F cdfs -r /dev/cdrom/CDROM_LUN /mnt/cdrom
b
Copy the file hpnapps.tarto /tmp, by entering the following
command:
cp /mnt/cdrom/periph/nraidadp/unixware/us/hpnapps.tar /tmp
Installing the Controller Management Software
5-9